Cylinder head wear... |
07-06-2017, (Subject: Cylinder head wear... ) Post: #10 | |||
| |||
RE: Cylinder head wear... I'd replace the cam and any rollers that don't pass inspection. As far a bearings go, well I'd probably replace them too. Per cummins they can run as long as copper is no more than 180* of the inside of the bearing. I don't know that I would worry about the head if it was running good, with no oil or coolant loss. | |||
« Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.