Rawze.com: Rawze's ISX Technical Discussion and more / Big Truck Technical Discussion... / ISX Related Help / ECM power supply lost with ignition turned on...

new reply
ECM power supply lost with ignition turned on...
02-13-2018, (Subject: ECM power supply lost with ignition turned on... ) 
Post: #7
Rawze Offline
Forum Reject  (13903 Likes)  *******

 		Posts: 10,996
Joined: Jun 2013
Thanks: 5883
Given 13903 thank(s) in 6071 post(s)
RE: ECM power supply lost with ignition turned on...
Cummins code 1117 (Power Supply Lost With Ignition On - ...) is also commonly seen during re-programming of the ECM. The code is basically saying that the ECM has been reset for some reason without the power being cycled properly. It is quite normal to see the code pop up after a flash, then need to be cleared once... but for it to happen without someone re-flashing the ECM is not common to see at all. It is usually related to power wiring issues either by the main power harness or the ignition switch circuits.

I would not rule out a corrupt ECM program or a failing ECM possibly causing it too.

User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!.
Return to Top | find
replyreply
 Thanks given by: Signature620 , Wiseman , Meatbag
new reply


Messages In This Thread
RE: ECM power supply lost with ignition turned on... - Rawze - 02-13-2018



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.
Theme by MyBB Addict
Contact Us | Rawze.com | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication