Low boost, higher egt's
04-14-2016, (Subject: Low boost, higher egt's ) 
Post: #13
RE: Low boost, higher egt's
I disconnected small pipe(was clean) from exhaust manifold going to exhaust pressure sensor housing and then checked with insite(engine off) It was showing same 30inhg 0.88V. Then I took sensor out of housing and left connector on it , checked insite (engine off) it was same 30inhg (which is ~15psi)!!! Then I took connector off and checked insite, now shows 0ingh-0v. I am thinking this is bad sensor? or bad harness?


User's Signature: Cascadia ISX15 CM2350
replyreply


Messages In This Thread
RE: Low boost, higher egt's - simon999 - 04-14-2016



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.