My Pete rebuild

[Rawze]

Just an FYI for those people who are not familiar with this stuff ..

: The tolerance on the B&S depth gauge is 0.003mm / 3-microns / 0.000118". ~ roughly the same as the starrett that was listed and better than the Mitutoyo. But like I said, they would all work to measure liner height to a satisfactory level. - My own experience with getting Mitutoyo equipment re-certified every year (I used to have to have this done) was pretty poor on all but their most high end o their stuff. Many times they came back as bad and I had to replace them. B&S on the other hand (my favorite brand of the past) I never really had a problem with. Starrett is also pretty good. - Really though, it depends on what you are getting and the requirements of your application. All brands of precision measuring equipment typically have 2 markets they try to satisfy. A "competitive version" that is less accurate, will fail re-certification after a moderate amount of use, or "high precision" versions that are more expensive but easily re-certifiable after a moderate amount of use. A sort-of "you get what you pay for" kind of internal clockworks in them.