My Pete rebuild

[Nostalgic]

I wish it wasn't so easy to lose my focus... I have a million things to get done, but end up hopping from one to another and never seem to accomplish anything.

Vent on one tank was plugged up and pressurized the tank that was drawing down - easy fix there at least. I pulled the fuel level sender to find it has quite a few dead spots on it, so will pick up some new senders at some point today. Fought one strap loose, and was pleasantly surprised to see next to no corrosion. Some kind of sticky (adhesive?) on the webbing seems to have kept the crud out.



I think my time could be better wasted in other areas than dropping the other 3 straps at this point.

With exceptions of the breakouts under the fifth wheel, most of my wire and airlines is split loomed and secure.



Which means I'll probably have to cut all of the zip ties again when I run a line for trailer axle dump and lift ISO socket lol. Headache rack is ordered so that I can figure out how I need to route the air lines, but until then, they'll have to hang out on the back of the sleeper. Not cutting anything anymore until I'm 100% sure it won't end up being an inch too short...