Program questions

[Lonestar10]

went in found that setting was set to 4250 or so FT lbs adjusted to 7000 like yours now i can actuatly get the boost needle to bounce off 0 to about 10psi at 80k from a stop in 1-4.


still no wee puffers a smoke so shes either running just purrrrfect as far as fuel to air or somewhat lean. watching turbo during shifts itll go from 60% to literaly 15% on commanded and start opening during a shift which i glide shift gear to gear so its maybe 1-2 seconds between gears so might be a little harsh on the actuator going to top end then falling basically full open and right back to top end.

truck really doesnt seem to have a cruise while using your foot i swear as soon as i push the pedal maybe 1inch its screaming for 20+ psi of boost and empty its impossible to maintain a speed as its basicaly accell or decell.