Kingpin settings
07-23-2019, (Subject: Kingpin settings ) 
Post: #1
Kingpin settings
Have difficulties to understand clearly how to change kingpins.
Manual says to torque 200 ft-pound and check is knuckle turns freely then torque to 600 ft-pound. I understand that 600 need to drive king pin all the way inside the tapper hole in axle but bearing is locked with such high clamping force. What is missed in manual or something I just got wrong.
STEMCO M536M.
./uploads/201907/post_1794_1563925311_15124ab9eceb2d1f868b38500adba49b.jpg
replyreply
07-23-2019, (Subject: Kingpin settings ) 
Post: #2
RE: Kingpin settings
Maybe its torque to 600 to seat everything and then back it off and torque to 200 and leave it ??


User's Signature: im_seeing_parameters_in_my_sleep 1
replyreply
 Thanks given by: snailexpress
07-24-2019, (Subject: Kingpin settings ) 
Post: #3
RE: Kingpin settings
Is that Stemco number right? The only number I can find close is a K536M quick kit? It goes to a Mack.
replyreply
07-24-2019, (Subject: Kingpin settings ) 
Post: #4
RE: Kingpin settings
(07-24-2019 )Chamberpains Wrote:  Is that Stemco number right? The only number I can find close is a K536M quick kit? It goes to a Mack.
Yes Mack and Volvo. Mack use no shims. Shims in Volvo kit.
replyreply
07-24-2019, (Subject: Kingpin settings ) 
Post: #5
RE: Kingpin settings
According to the manual, the final torque is 600 ft-lbs. -- You first torque it to 200 ft-lbs, then rotate it around a bit (with the jack out of the way) to ensure everything centers itself up before making the final torque adjustment.

http://www.stemco.com/f/qbin/01-577-1005...-sheet.pdf


User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!.
replyreply




NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.