C15 6nz Inframe time
08-19-2019, (Subject: C15 6nz Inframe time ) 
Post: #13
RE: C15 6nz Inframe time
(08-18-2019 )Unilevers Wrote:  the {name removeed} steel liners are no joke and good stuff. They are hands down tougher and ductile than standard cast iron - we have been using steel on cats for a long time now and im never going back to cast liners again. that being said at modest HP levels no it probably isnt going to gain alot out of it but there is no reason to not as they dont have any reduced service life.

{name removeed} started making steel liners because i whispered sweet nothings in certain peoples ears. this is not market "trick" its really being produced to solve a certain high horsepower demand that cast liners have issues with. You can reduce the wall thickness of the liner by going to steel and can run bigger bore and more displacement. They called me to help them get that engine to run on the dyno without a truck lol.

i too have forgotten that link i posted for cats, ill do some digging.

found it!

http://rawze.com/forums/showthread.php?t...2#pid37852

Unileversssss just the man I was trying to get attention from!

Hahaha sweet nothings

Mate I’m glad you posted this reply thanks heaps! Few more questions should we use the crevice seal design liner or just go standard? Just spoke to them and they don’t have steel liners for the Cat engines only for the ISX. The standard kits include cast liners and articulated 2 piece pistons will that be ok or go 1 piece steel? Only running 550hp.

Thanks mate
replyreply


Messages In This Thread
RE: C15 6nz Inframe time - Unilevers - 08-18-2019,
RE: C15 6nz Inframe time - multitask - 08-19-2019
RE: C15 6nz Inframe time - Unilevers - 08-21-2019,
RE: C15 6nz Inframe time - Unilevers - 08-21-2019,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.