Help low boost
02-28-2016, (Subject: Help low boost ) 
Post: #46
RE: Help low boost
After the fact but what ever you did worked. Nice new actuator looking good!

I posted this pre apocalypse.From Orange tractor.com ----------------------

"Ran across this file while looking for information on freeing up plungers on a Cat engine.

It's about 3 years old, but shouldn't matter.

I get the acetone in a qt. can at Wal Mart paint dept.


Machinist's Workshop MagT recently published some information on various penetrating oils. The magazine reports they tested penetrates for break out torque on rusted nuts.They are below. They arranged a subjective test of all the popular penetrates with the control being the torque required to remove the nut from a "scientifically rusted" environment.

Penetrating oils ........... Average torque load to loosen

No Oil used ................... 516 pounds
WD-40 ..................... ... 238 pounds
PB Blaster .................... 214 pounds
Liquid Wrench ...............127 pounds
Kano Kroil .................... 106 pounds
ATF*-Acetone mix............53 pounds

The ATF-Acetone mix is a "home brew" mix of 50 - 50 automatic transmission fluid and acetone. Note this "home brew" released bolts better than any commercial product in this one particular test.

ATF-Acetone mix is best, but you can also use ATF and lacquer thinner in a 50-50 mix.

*ATF=Automatic Transmission Fluid.


User's Signature: 2010 386 Pete CM871, 13 spd. 3.55
replyreply




NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.