Pressure testing CM870
11-03-2019, (Subject: Pressure testing CM870 ) 
Post: #13
RE: Pressure testing CM870
I built all my tester out of pvc figured if the glues good for 60-90 psi water good enough for 20-30 of air. Just drilled/tapped the caps for pressure regulator then put a washer and retaining nut on inside of pipe on regulator then glued and clamped boots on them


User's Signature: 2010 Lonestar - CM871 - 13sp - 3.70s, 2016 T680 - cm2350 - 13sp - 3.36s - skateboarder
replyreply


Messages In This Thread
RE: Pressure testing CM870 - Lonestar10 - 11-03-2019



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.