Cam bearings
07-28-2016, (Subject: Cam bearings ) 
Post: #19
RE: Cam bearings
(07-28-2016 )jimeneztrans84 Wrote:  Is there a way or anyone done a oil bypass filter for cm2250?

With correct remote touch on the ECM , there's no need for oil bypass filter , because oil stays almost sparkling clean .
replyreply
07-28-2016, (Subject: Cam bearings ) 
Post: #20
RE: Cam bearings
(07-28-2016 )Wiseman Wrote:  
(07-28-2016 )jimeneztrans84 Wrote:  Is there a way or anyone done a oil bypass filter for cm2250?

With correct remote touch on the ECM , there's no need for oil bypass filter , because oil stays almost sparkling clean .

That remote computer stuff sure is convenient, but the extra time to go meet the guy that will tune it and drive it then re-tune it to get that little extra fuel $ that adds up for the next years....as well as the guy that replaces the dealer when I have problems in the future. Worth the trip to me.
replyreply
07-28-2016, (Subject: Cam bearings ) 
Post: #21
RE: Cam bearings
(07-28-2016 )yamajason Wrote:  
(07-28-2016 )Wiseman Wrote:  
(07-28-2016 )jimeneztrans84 Wrote:  Is there a way or anyone done a oil bypass filter for cm2250?

With correct remote touch on the ECM , there's no need for oil bypass filter , because oil stays almost sparkling clean .

That remote computer stuff sure is convenient, but the extra time to go meet the guy that will tune it and drive it then re-tune it to get that little extra fuel $ that adds up for the next years....as well as the guy that replaces the dealer when I have problems in the future. Worth the trip to me.
You're absolutely right!!!!
replyreply
07-28-2016, (Subject: Cam bearings ) 
Post: #22
RE: Cam bearings
Is the bypass hookup for cm2250 and 871 just about the same?
replyreply
07-28-2016, (Subject: Cam bearings ) 
Post: #23
RE: Cam bearings
(07-28-2016 )jimeneztrans84 Wrote:  Is the bypass hookup for cm2250 and 871 just about the same?
Yes it is
http://rawze.com/forums/showthread.php?tid=431
replyreply
07-28-2016, (Subject: Cam bearings ) 
Post: #24
RE: Cam bearings
Where did you get that fitting that screws on the side of the block? Size?
replyreply
07-30-2016, (Subject: Cam bearings ) 
Post: #25
RE: Cam bearings
(07-28-2016 )jimeneztrans84 Wrote:  Where did you get that fitting that screws on the side of the block? Size?

The size for the fitting in the oil cooler is M14 to #8 jic
Return line into the block is M18 to #8 jic. You can get them at some hydraulic stores. I prefer steel fitting.
Be sure not to over torque them.

Tags:
bypass oil fittings,bypass,oil bypass,oil plugs
replyreply




NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.