CM2350 gear housing gasket |
02-09-2021, (Subject: CM2350 gear housing gasket ) Post: #12 | |||
| |||
RE: CM2350 gear housing gasket Pull the crank pin back out and turn the engine 360 degrees then the cam wedge will fit. If you look you will see the flat edge on the cam is on the inside. Turning the crankshaft 1 full turn and pinning it again will put that flat spot on the outside and the wedge will fit. | |||
|
« Next Oldest | Next Newest » |
Messages In This Thread |
CM2350 gear housing gasket - eggtrucks - 02-08-2021, RE: CM2350 gear housing gasket - Mattman - 02-08-2021, RE: CM2350 gear housing gasket - Mattman - 02-08-2021, RE: CM2350 gear housing gasket - Waterloo - 02-08-2021, RE: CM2350 gear housing gasket - Pigpen 2869 - 02-08-2021, RE: CM2350 gear housing gasket - SemiSweet - 02-08-2021, RE: CM2350 gear housing gasket - Rawze - 02-09-2021, RE: CM2350 gear housing gasket - tree98 - 02-08-2021, RE: CM2350 gear housing gasket - Rawze - 02-09-2021, RE: CM2350 gear housing gasket - eggtrucks - 02-09-2021, RE: CM2350 gear housing gasket - eggtrucks - 02-09-2021, RE: CM2350 gear housing gasket - Starlight - 02-09-2021 |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.