11-19-2020,
(11-19-2020 )Koren Wrote: [ -> ]Thanks for the replies. All of the pulleys spins fine. But I can't manually spin the crankshaft.
I tried to set up with Haggai but they are busy till December 7. I'm stopping driving at this time but I'm afraid I have to find a shop first since it probably won't start at all after I leave it for a couple of days.
Any shops you guys can recommend in GA/FL area who does an inframe?
How do I pull out the copy of the software of the ECM?
Just wait for haggai.. Theyre they only shop that is close to you that will build it right!