+- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums)
+-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1)
+--- Forum: Ask Your question... (/forumdisplay.php?fid=45)
+--- Thread: Cm2350 no power (/showthread.php?tid=4903)
RE: Cm2350 no power - Lonestar10 - 08-06-2019
30-35psi is also the max you want on a 2350 if it's not making the power is supposed to in that range then something is either wrong with the engine or wrong with the tuning.
RE: Cm2350 no power - SquareOne - 08-06-2019
(08-06-2019 )Lonestar10 Wrote: ....30-35psi is also the max you want on a 2350....
^THIS
Ya beat me to it Lonestar lol
RE: Cm2350 no power - Lonestar10 - 08-06-2019
*Snickers in his dark corner*
RE: Cm2350 no power - trucklogger2 - 08-06-2019
(08-06-2019 )Tattoo76 Wrote:(08-05-2019 )trucklogger2 Wrote: Is it a derate or just sluggish? Low boost? I would keep it simple at first and check seal on fuel/water separator ( maybe even multiple times if no change) then check charge air system.
I would suspect rail press Gauge if derate or injector maybe?
Just ideas there.
Not derate I'm positive of that, it pulls fine until I start pulling some hills then fall on its face. I have to drop some times down to 10th in PA and WV pulling tanker, 18sp 550 hp 3.42 rears
I would definitely try another fuel pressure sensor or press relief valve . Or try that hill again and monitor insite at the same time to try and pinpoint problem.