[split] Well, she bit the dust, In Frame this week... - Printable Version +- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums) +-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1) +--- Forum: Ask Your question... (/forumdisplay.php?fid=45) +--- Thread: [split] Well, she bit the dust, In Frame this week... (/showthread.php?tid=341) |
RE: Well, she bit the dust, In Frame this week... - Texasdude74 - 04-16-2016 Other side RE: Well, she bit the dust, In Frame this week... - Waterloo - 04-16-2016 (04-16-2016 )Texasdude74 Wrote: Other side Looks PURDY! RE: Well, she bit the dust, In Frame this week... - Texasdude74 - 04-16-2016 It's a FrankenCat. Hodge podge of the best parts. Mostly Acert stuff, little bridge motor, shot of marine and even a dash of an industrial application. 70 pin ecm 16:1 compression Actuators are present but not functional, ecm couldn't run them if it wanted to. Nothing too crazy, just an honest 1k horses. Best part? Still $8k CHEAPER than an emission truck woulda been! RE: Well, she bit the dust, In Frame this week... - Texasdude74 - 04-16-2016 Rear shot. RE: Well, she bit the dust, In Frame this week... - Waterloo - 04-16-2016 I can believe it... If I had it to do all over again, I would have found an old Pete and restored her, I could have two sitting in my driveway right now with the monies I have lost and invested into this current truck. RE: Well, she bit the dust, In Frame this week... - Texasdude74 - 04-16-2016 36" bunk 260" wheelbase Disc brakes 2050 driveline New 18 speed 14.6k lb car hauler front axle with car hauler low, low air leaf. Platinum interior, leather Atlas seat and wood grain dash. $156k all in. Truck is in Jacksonville where the roof will be chopped 8" and cab lowered another 4". $8k for the mods but would have been done emission truck or not. Then a headrack will be built on it, won't haul its first load until some time in July. One year build time basically. RE: Well, she bit the dust, In Frame this week... - Rig Wrench - 04-16-2016 (04-16-2016 )gearhead Wrote: You must like what you are doing to be good at both computer side and the nuts and bolts side. No one wants to do the nuts and bolts anymore the new generation doesn't want nothing to do with it. It's a dieing bread to say the least. I resent that comment gearhead RE: Well, she bit the dust, In Frame this week... - Rig Wrench - 04-16-2016 (04-16-2016 )Texasdude74 Wrote: It's a FrankenCat. Dyno sheet? RE: Well, she bit the dust, In Frame this week... - Rig Wrench - 04-16-2016 (04-16-2016 )Texasdude74 Wrote: Other side Why not ditch the PreCooler? Like so |