CM871 vs CM2250 bottom end |
03-15-2017, (Subject: CM871 vs CM2250 bottom end ) Post: #10 | |||
| |||
RE: CM871 vs CM2250 bottom end The compressor is not interchangeable. 871 compresor has 4 bolts going into the gear housing, whereas the 2250 has 1 stud and 1 long bolt from the gear housing. If I were you I'd buy a long block and clean, then change over the external components. That way there's no guesswork and the important bits are covered by Cummins. | |||
« Next Oldest | Next Newest » |
Messages In This Thread |
CM871 vs CM2250 bottom end - Liquidforce - 03-13-2017, RE: CM871 vs CM2250 bottom end - Rawze - 03-14-2017, RE: CM871 vs CM2250 bottom end - Running rough - 03-14-2017, RE: CM871 vs CM2250 bottom end - Rawze - 03-14-2017, RE: CM871 vs CM2250 bottom end - Running rough - 03-16-2017, RE: CM871 vs CM2250 bottom end - Rawze - 03-16-2017, RE: CM871 vs CM2250 bottom end - Running rough - 03-16-2017, RE: CM871 vs CM2250 bottom end - Mr Hagg - 03-14-2017, RE: CM871 vs CM2250 bottom end - Liquidforce - 03-14-2017, RE: CM871 vs CM2250 bottom end - Signature620 - 03-14-2017, RE: CM871 vs CM2250 bottom end - hhow55 - 03-14-2017, RE: CM871 vs CM2250 bottom end - Liquidforce - 03-14-2017, RE: CM871 vs CM2250 bottom end - Signature620 - 03-15-2017 RE: CM871 vs CM2250 bottom end - Running rough - 03-17-2017, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.