Possible lift pump problem???

[Hammerhead]

(06-13-2017 )tree98 Wrote:  I checked the wiring today, I'm getting 12V to pin 85 of the relay for about a minute after I turn the key on then it goes out. No power to any other pins. Shouldn't there be a constant 12V to one of the relay pins?

Sorry, I didn't read your post properly.
Quickserve procedure 005-045 Fuel Lift Pump for diagnostics.

Yes, there should be a "Supply Line" (constant +12v), a "Signal Line" (timed +12v), and a "Return Line" (to chassis ground). The other two are the circuit to and from the lift pump and fuse circuit itself.
If you ONLY have +12v power to pin #85, then YES you have a power supply issue. Trace and check the wiring harness for damage.

Here is the wiring diagram and the connector for you.