Truck rear turn signal and stop on different wire?

[frameless1]

(04-26-2018 )Rawze Wrote:  for cars, standard turn signal and brake signal colors on rear of vehicle are both red for USA. Turn signal requirement is AMBER for eu and other countries and brake light is red. I think amber rear turn signal lights is allowed for cars here in usa to accommodate foreign model cars, but for trucks? Who knows.

Not sure what the requirement on commercial vehicle is in the USA for allowed rear turn signal light colors, maybe look it up to make sure what you are trying to do is legal. I would also think that side-marker lights on the tractor would have the signal you are looking for.

Maybe I should have posted it differently but in my head it sounded like I was going to confuse people and they might go after the wrong part of the question, so let me clarify cuz that’s just what has happed. I need to connect the truck turn signal at the back of the frame separate from the brakes I’m installing fenders with 3 lights on them. Now those lights are going to have a blinker sequencer for each turn signal, so if I connect it how it is right now (or any other truck) the blinker will turn on the sequencer but so will the brakes cuz they are on the same wire. In order to stop this I need a 4wire feed to the sequencer, which is brake, turn, corner and ground.
I was trying to find more info but nothing worthwhile so far I have connected the fenders lights to work with only three wires so if I put the blinker they all work as one