Low oil pressure after shim
05-22-2018, (Subject: Low oil pressure after shim ) 
Post: #12
RE: Low oil pressure after shim
The oil passage essentially shuts down to that cylinder/piston rod, pressure drops. The bearing rotates on the crankshaft, closing off the oil passage. Messy job, but with the right tools a doable PIA job to fix in your driveway. Replace them all, if that is the issue. Use plenty of Permatex Ultra Slick and be sure the clutches go in correctly. ;-)
replyreply
 Thanks given by: Hammerhead


Messages In This Thread
RE: Low oil pressure after shim - Unilevers - 05-22-2018,
RE: Low oil pressure after shim - Waterloo - 05-22-2018



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.