Intermittent CM2250 stalling only at idle |
05-30-2018, (Subject: Intermittent CM2250 stalling only at idle ) Post: #5 | |||
| |||
RE: Intermittent CM2250 stalling only at idle (05-30-2018 )Unilevers Wrote: your probably not maintaining rail pressure. I would run a low side sight glass and check for bubbles, the fuel water separators leak alot. if not could be a pump actuator getting lazy or a lift pump cutting out/getting old aswell. I can now confirm it’s when the truck is going up a hill. It will stall out, lose power etc. however for the most part while driving it maintains rail presssure. Even when going up a hill the pump maintains pressure unless you come to a stop then it stalls. It’s a Paccar water separator btw. Rail pressure seems to hold when truck is off. I wanted to test lift pump by turning key but when I checked actual rail pressure was at 10.2K psi hours after engine was shut off. | |||
« Next Oldest | Next Newest » |
Messages In This Thread |
Intermittent CM2250 stalling only at idle - zyNoT - 05-30-2018, RE: Intermittent CM2250 stalling only at idle - jimeneztrans84 - 05-30-2018, RE: Intermittent CM2250 stalling only at idle - zyNoT - 05-30-2018, RE: Intermittent CM2250 stalling only at idle - Unilevers - 05-30-2018, RE: Intermittent CM2250 stalling only at idle - zyNoT - 05-30-2018 RE: Intermittent CM2250 stalling only at idle - Rawze - 05-30-2018, RE: Intermittent CM2250 stalling only at idle - zyNoT - 05-30-2018, RE: Intermittent CM2250 stalling only at idle - Mr Hagg - 05-30-2018, RE: Intermittent CM2250 stalling only at idle - zyNoT - 06-01-2018, RE: Intermittent CM2250 stalling only at idle - Chamberpains - 05-30-2018, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.