Program questions |
05-01-2019, (Subject: Program questions ) Post: #6 | |||
| |||
RE: Program questions went in found that setting was set to 4250 or so FT lbs adjusted to 7000 like yours now i can actuatly get the boost needle to bounce off 0 to about 10psi at 80k from a stop in 1-4. still no wee puffers a smoke so shes either running just purrrrfect as far as fuel to air or somewhat lean. watching turbo during shifts itll go from 60% to literaly 15% on commanded and start opening during a shift which i glide shift gear to gear so its maybe 1-2 seconds between gears so might be a little harsh on the actuator going to top end then falling basically full open and right back to top end. truck really doesnt seem to have a cruise while using your foot i swear as soon as i push the pedal maybe 1inch its screaming for 20+ psi of boost and empty its impossible to maintain a speed as its basicaly accell or decell. | |||
« Next Oldest | Next Newest » |
Messages In This Thread |
Program questions - Lonestar10 - 04-26-2019, RE: Program questions - Nilao - 04-26-2019, RE: Program questions - Rtrucking - 04-26-2019, RE: Program questions - Magard - 04-27-2019, RE: Program questions - Lonestar10 - 04-27-2019, RE: Program questions - Lonestar10 - 05-01-2019 RE: Program questions - Nilao - 05-01-2019, RE: Program questions - Lonestar10 - 05-01-2019, RE: Program questions - ynot - 05-01-2019, RE: Program questions - Lonestar10 - 05-01-2019, RE: Program questions - Rawze - 05-02-2019, RE: Program questions - Lonestar10 - 05-02-2019, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.