IFSM O-rings

[Rawze]

(03-02-2021 )dhirocz Wrote:  I'll be cutting the counter bores as soon as my liner shims arrive. It'll be a first for me, though I'm familiar with the theory. I'll cut it some, install it and compress it, measure it, cut some more... I'll probably have a day just in doing that. Picked up the same tool rawze uses to do the job from a shop closing down.
...

All I do is cut the ledges all to the same depth according to how far I want them to stick up...
http://rawze.com/forums/showthread.php?t...9#pid28349

If your using the same too that I use, watch it carefully. they tend to cut one side a bit deeper than the other and you have to adjust the torque on the retaining bolts till you get it even.

Also, I only ever take 0.001" cuts at a time. Otherwise you get chatter and/or wear out the cutter.