Help Code 2636

[BLAKE7700]

I was going to send you a file today but with the help of another member on this forum the problems have been found and fixed. First problem was a missing terminating resistor so I added a 120 ohm resister to the circuit. Still did not fix it but after that I was getting the correct resistance readings on the data ink wires. For the other problem i was not getting the correct amount of voltage to the vgt actuator from the ecm. I tested the brand new engine harness and it was good. Had battery voltage going into ecm had 9.7 volts coming out of ecm pin 10 on engine harness connector one for the vgt actuator supply. I was ready to put a ecm on it thinking it was bad. A very helpful member of this forum talked to me over phone and looked at the ecm file through team viewer and determined it needed a different ecm file. The new file was uploaded using calterm and insite and that fixed my problem. I had battery voltage coming out of ecm on pin 10 for engine harness connector one going to vgt actuator connector and I had battery voltage at vgt connector. No code. No stop engine light. The truck ran way smoother and was more responsive. I am sorry I didnt check the ecm file sooner, I was told more than once there shouldn't be anything wrong with the ecm file through efi so I keep looking for other causes. I haven't test drove truck since i am still waiting on new exhaust flange so I can hook the exhaust up, but my problem seems to be fixed. Thank you so much for everyone's help and input!!