Autoshift gets stuck in 10 gear
09-26-2016, (Subject: Autoshift gets stuck in 10 gear ) 
Post: #13
RE: Autoshift gets stuck in 10 gear
(09-26-2016 )sbtrucking Wrote:  Where on top of the transmission is this sensor located?

The sensor I changed was on the front top of transmission, sitting in truck to the right side on top where the shifter would normally be. If you remove the plate that covers the spot where the gear shifter would be its on top towards the right a little. There are multiple sensors on the transmission. Mine was the input shaft sensor about $50.00. Easy to get to but might be hard to pull out the old one. If you have to break the old one to get out make sure you get the little magnet out. The magnet is encased in the sensor but if you have to break the casing be aware to make sure the old magnet comes out.
replyreply


Messages In This Thread
RE: Autoshift gets stuck in 10 gear - RojoPete - 09-26-2016
RE: Autoshift gets stuck in 10 gear - Unilevers - 09-26-2016,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.