Metering actuator issue
04-19-2024, (Subject: Metering actuator issue ) 
Post: #7
RE: Metering actuator issue
Well did leak test and they all passed no bubbles. Actuators all passed ohm test. Swapped actuators and it still says rear bank actuator code. So when driving it’s not a constant rough run it is fine then goes to shi#t and engine light pops on then smooths out and it goes away. Bob tail it won’t do it at all but as soon as I hook to trailer it will act up. I tried to check the harness but I think I need a nicer multimeter bc I was having issues getting contact. The plug for the actuator look fine as well so I’m at a loss. I also ran the cit out test again no problems and did the injector test on insite as well they all passed.


User's Signature: 2010 kenworth t800 isx500hp cm871 13spd 3.55ratio
replyreply


Messages In This Thread
RE: Metering actuator issue - Scoot5869 - 04-19-2024



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.