Grinding/growling noise coming from rear end

[Redland1]

(08-31-2025 )marek4792 Wrote:  Gotta find your manufacturers specs on the interwebs on ride height. But finding a wore out valve is easy because in its resting position the arm should be sitting parallel with the valve body, and fail by resting slightly upward causing your rear end to sit lower then normal.

Found a post on an International 9900i FB page that says 2.5” from top of Ubolt to bottom of frame. Mine is at 3”. Do I just cut .5” off the rod or is there another way to do it ?