Reprogram issue :/

[Rawze]

(02-05-2020 )2dlb Wrote:  

(01-30-2020 )Rawze Wrote:  First thing I always do when someone comes over here is make a pdf document printout of the entire 'Features and parameters' settings that are showing in insite before making any kind of changes. Seen this happen too many times.

- as a last resort, you can pull the ecm off the truck, take it to the stealers%it and have them re-flash the ecm with the latest calibration and restore the original settings for your truck. - Usually costs a few hundred bucks.

I tried to do this, where can i find instructions on the procedure i have a file i would like you to look at.
Thanks

just open up the 'features and parameters' section in insite, expand all, then print it out.


I think doing a complete ecm report, it is included as well.