Timing set

[medicsaps]

I have it back together now. I have the exact wedges that chamberpains posted pick of. Will be replacing the timing gear cover gasket soon and was testing the kit while doing an overhead set. The tab on the bottom hits the casting of the head (medial to the machined surface) before the wedge seats, there is still about .050 inch gap between the wedge and the flat on the cam. I bought the truck used and just wondered if it may be an aftermarket head. It is a single cam if that matters. Rawze there not a video that you have put out that I have not watched multiple times. I appreciate everyone on this site, thanks for the advice