Throw out bearing replacement

[Chamberpains]

The throw out bearing is a part of the clutch. You will be replacing the clutch to replace it. A rattle alone is not a good enough reason to pull the clutch. Make sure all the clutch linkages are in good shape and lubed up. Also make sure the clutch fork cross shafts are lubed. If everything is tight and lubed then look into pulling the clutch. I had a pilot bearing go out on my international 9400i that made a constant rattle for many miles. Someone didn't replace it or installed it wrong when they put the last clutch in. This was yet another costly mistake that I paid a shop good money for.