Increasing HorsePower -- What You Need To Know
04-27-2023, (Subject: Increasing HorsePower -- What You Need To Know ) 
Post: #152
RE: Increasing HorsePower -- What You Need To Know
(04-21-2023 )Rawze Wrote:  
(04-21-2023 )jrbmechanical Wrote:  ...
Is there a place where I can look up which incal file number is compatible with which one?
...

The only way to actually tell for sure is to convert the entire file into plain English (using Calterm or other software) and then compare it against another file in question to see what in fact is different.

The CPL and other data that Insite shows is often misleading.


Ok thank you sir, would EF10398.17 or EF10399.17 be a direct comparison for EF10392.17 or EF10394.17?

ECM took the EF10394.17 file. Customer wants to be at 600HP and 2050FTTQ


Also I am running into an error when trying to connect Calterm to the ecm, it says "Length cannot be less then zero. Parameter name: length.

Reason I trying to connect with calterm is even though all of the load based speed control and other similar parameters are maxed out and disable in insite, truck still falls on its face around 1700-1800 rpm. Trying to see in calterm all of the other parameters are disabled that you had listed in another posting about LBSC


Attached File(s)Image(s)
./uploads/202304/post_6422_1682595913_9563b48055baa804a33b43bb97318126.png
replyreply


Messages In This Thread
RE: Increasing HorsePower -- What You Need To Know - jrbmechanical - 04-27-2023



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.