Injectors
01-08-2017, (Subject: Injectors ) 
Post: #46
RE: Injectors
A couple of weeks ago ,our T700 with a 2250, began miss-firing intermittently.
My son hooked up Insight and found it had thrown code 0325.
The code states low voltage from #6 injector solenoid.
We opened Cummins quick serve and followed the trouble shooting procedure.
Found one wire loose on top of the solenoid, tightened it down.
After 200 miles problem came back and began getting worse.
The only thing that we could determine was that the solenoid on #6 injector was
bad. We called several dealers and found that the solenoid was bulit into the injector & not serviceable.

The truck was under a load near Shreveport Louisana.
Cummins dealer in Shreveport had the injector.
Found a truck stop nearby, so with flashlight in hand. Using Insight from home was able to walk my son thru bleeding pressure, installing the injector,entering the trim codes, and finally pressure testing the system.

That has been 3000 miles ago and all seems fine.
WITH OUT THIS FORUM we could not have accomplished this.
Insight and Quickserve were both a result of being a member here.

Special thanks to: Allison at Mr Haggs shop
Rawze tips on how to accomplish this
Unilevers for the help with Insight

T700[/size]
replyreply
 Thanks given by: Rawze , Hammerhead , LargeCar
07-08-2019, (Subject: Injectors ) 
Post: #47
RE: Injectors
(12-28-2016 )race7820000 Wrote:  https://youtu.be/8hDHeTUAIeA

You can hear the chirp/squeak noise in video

When I switched actuators the noise went from back 456 to 123.

I really thought it was actuators because the noise follow them when u changed them.

It also does it if u run one at a time on whatever set of 3 is doing it.

Hey did you end up working out the chirping/squeaking sound?
replyreply
07-08-2019, (Subject: Injectors ) 
Post: #48
RE: Injectors
(01-06-2017 )hhow55 Wrote:  Maybe, someone would do a video on how to do this procedure.

Hmmm...I have a box of injectors at the house too. I wonder if quickserve has anything on injector assembly/disassembly?


User's Signature: 2010 T2000, CM871, 13spd, 977k, tanker yanker
Overhauled @ 927k
replyreply
07-09-2019, (Subject: Injectors ) 
Post: #49
RE: Injectors
(07-08-2019 )dhirocz Wrote:  
(01-06-2017 )hhow55 Wrote:  Maybe, someone would do a video on how to do this procedure.

Hmmm...I have a box of injectors at the house too. I wonder if quickserve has anything on injector assembly/disassembly?

There used to be for the really old style injectors. but then again, here is the issue with trying to rebuild more modern injectors...
http://rawze.com/forums/showthread.php?t...67#pid4367


User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!.
replyreply




NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.