cm 871 regen fail
02-25-2020, (Subject: cm 871 regen fail ) 
Post: #3
RE: cm 871 regen fail
(02-25-2020 )tree98 Wrote:  for starters you need to do an egr tune up https://www.youtube.com/watch?v=FhJxpyS5MpY Those sensors must be replaced not cleaned. The IMAP in particular has the pressure sensor up inside it and you can't get to it to clean it.The readings your looking at could be incorrect if the sensors arent reading right. Replace the doser also, it may not be spraying properly, that could cause it to not get up to temp during a regen. When you say the dpf and doc were cleaned "properly" what exactly does that mean? How did you clean them?

cleaned with this:

./uploads/202002/post_4856_1582687204_3f23c8fff3ccaea8fb314f448ba124d3.jpg
https://www.youtube.com/watch?v=0PVSz-F2x6A


i was leaning toward the turbo because it seemed to get worse as it warmed up but i didnt feel all warm and fuzzy about replacing it. its expensive and i didnt want to blow somebody elses money on it if it didnt need it. my plans were to replace those sensors and doser tomorrow and clean the egr valve and piping. then see what kind of regen it does after that. i think i will remove the turbo actuator and check the turbo linkage as well for binding. i just figured it would be worth a shot to post it on here a get a different opinion. thanks for the reply.
replyreply


Messages In This Thread
cm 871 regen fail - NavistarIH - 02-25-2020,
RE: cm 871 regen fail - tree98 - 02-25-2020,
RE: cm 871 regen fail - NavistarIH - 02-25-2020
RE: cm 871 regen fail - Rawze - 02-26-2020,
RE: cm 871 regen fail - hhow55 - 02-26-2020,
RE: cm 871 regen fail - Rawze - 02-26-2020,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.