cummins isx15 injector

[Ibanes]

(05-03-2021 )Rawze Wrote:  

(05-03-2021 )Ibanes Wrote:  

(05-03-2021 )Rawze Wrote:  

(05-03-2021 )Ibanes Wrote:  ...
a cummins isx15
... truck has the following codes # 3545, #1144 active and inactive are codes #3253, #3311

...i tried to run re-gen and it fails..
...

You did not specify what year/model ISX it is. CM2250?, CM2350? -- Maybe an Engine ser#? (ESN#)?. That way those codes can be properly looked up on Quickserv?

ASLO...

DID YOU verify the actual part#'s of those exhaust elements you pulled out of that other truck? .. Just because it is the same make/model truck does not mean it does not have updated, or different capacity units. What is the engine ser# (esn#) of the truck they were taken from?. That way it can also be looked up.

cm2350 engine serial # 79703419 esn# 79703419 p/n 5317106 s/n 4003057 d/c 11202013 e/c ef10054.16-80000

Active codes according to your post ...

3545 - Aftertreatment Outlet NOx Sensor (is not communicating / unplugged / missing).

1144 - Injector Solenoid for Cylinder 5 - (Stuck Solenoid detected).

and Inactive codes according to your post...

3253 - Aftertreatment 1 Diesel Particulate Filter (overheated during regen Moderately Severe Level ).

3311 - Aftertreatment 1 Diesel Particulate Filter (overheated during regen Very Severe Level).


==================


The DPF overheated... this is why it will not regen. this could be for many reasons including partially blocked up SCR to turbo closing too far due to intake or other restrictions... to the wrong program perhaps in the ECM.

- What program is in the ecm?... Has anyone changed it to "up the horsepower"?.. if so, put the origional program back in.

- Did the part#s for those units match that were taken off the truck with the one's put back on?

-- WHY would you have active codes for a missing NOx sensor. This is either the wrong program in the ecm, or something with it is bad. The entire system is not going to work unless you solve BOTH of those active codes.

-- DID you also include/move the entire DPF module that was strapped onto the outside DPF can from the other truck?,... or did you unhook it from the can and use the module that should have stayed with the truck>?

the injector code should not be present at all. it is not normal to get those codes unless something is wrong.

i will inspect all this info given today..i truly appreciate everyone here with advise. Will notify of what ever i find..