12-11-2017,
Hi everyone. First post in the forum. Not sure if this is the right forum to ask but here goes.
Recently, I bought a 2013 W900L with an ISX and I'm slowly learning about the truck and doing repairs that needed doing.
Today I took out the low beam lights and installed some Cree-style (Chinese knock off) LED lights in their place. (There were Speaker projector lights in before I swapped but one had burned out so I decided to try these lights.)
Here's my problem....they are working perfectly EXCEPT I have a Low Beam Fault on my dash now.
I'm surprised because I'm pretty sure the Speakers were LED and never had this fault message before the switch. Do I need to put a resistor inline somewhere?
Thanks for any help
Recently, I bought a 2013 W900L with an ISX and I'm slowly learning about the truck and doing repairs that needed doing.
Today I took out the low beam lights and installed some Cree-style (Chinese knock off) LED lights in their place. (There were Speaker projector lights in before I swapped but one had burned out so I decided to try these lights.)
Here's my problem....they are working perfectly EXCEPT I have a Low Beam Fault on my dash now.
I'm surprised because I'm pretty sure the Speakers were LED and never had this fault message before the switch. Do I need to put a resistor inline somewhere?
Thanks for any help