+- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums)
+-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1)
+--- Forum: Your Daily Blog (/forumdisplay.php?fid=77)
+--- Thread: Brock's 08 Pete 389 engine swap(Yellow to Red?) (/showthread.php?tid=5233)
RE: Brock's 08 Pete 389 engine swap(Yellow to Red?) - Rawze - 04-23-2020
e-mail me the file from your truck and i will update it for you and ensure it is correct.
RE: Brock's 08 Pete 389 engine swap(Yellow to Red?) - Brock - 04-23-2020
(04-23-2020 )Rawze Wrote:(04-23-2020 )Brock Wrote: I pulled a factory file from another member with a twin truck to mine, I ran the mm2w overlay then put it in my truck and drove it after changing all the parameters for my specific truck them I pulled the file and sent it to you.
I think I changed bunch of truck specific things in the cal as well I may have added 2 degrees on soi for some stupid reason (the timing was already done in the tables so I know I dont need soi) , I wasnt overly concerned doing that as the file was being sent to you before it leaves the yard.
all I know is that, in the file sent to me, that someone added 2+ degrees on the master setting ,.. but it also had +7 in the tables... this is way to much for the isx at high torque.
there are some other things that need to be updated as well before calling that fil
e "good".
maybe your using a severely out of date file or ocverlay?
The overlay I used is out of date but doesn't have the 2 degrees added, I did that myself. I'm guessing the overlay timing table was set up for lower hp.
Good thing I sent it to you before running down the road like a idiot!