+- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums)
+-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1)
+--- Forum: ISX Related Help (/forumdisplay.php?fid=68)
+--- Thread: Need help with 1st gen isx cm570 (/showthread.php?tid=3244)
Pages: 1 2
Need help with 1st gen isx cm570 - Ajr2000 - 06-23-2018
Truck will be running down the road just fine the red shut down light will come on. Killing the motor I had a check engine light on before this. Flash code said lose control. After the motor shut done had a code 187 low voltage or short. Check wiring harness couldn't find anything to cause this.[/size]
RE: Need help with 1st gen isx cm570 - Signature620 - 06-24-2018
Do you have access to Insite or someone who could check the fault codes for you?
RE: Need help with 1st gen isx cm570 - hhow55 - 06-24-2018
http://www.diesel-service-parts.com/isx-fault-codes.html
Check this out. I would first check voltage to the oil pressure sensor, then your vehicle speed sensor.
RE: Need help with 1st gen isx cm570 - Chamberpains - 06-24-2018
Register your engine on Cummins Quickserv for free and type in the code. It gives a full description of the code.
But if you're in need in a hurry...
[attachment=3992]
[attachment=3993]
[attachment=3994]
[attachment=3995]
RE: Need help with 1st gen isx cm570 - Ajr2000 - 06-24-2018
(06-24-2018 )Signature620 Wrote: Do you have access to Insite or someone who could check the fault codes for you?No I don't the truck is on the said of the road. I'm trying to get it back to my home town. I'm in the middle of oil field country a tow bill would be crazy out here.
RE: Need help with 1st gen isx cm570 - Ajr2000 - 06-24-2018
Also would like to add that when the shutdown light starts to flash when going do the road, if I take my foot of the throttle it will stop and you can drive for about 45 seconds till light comes on again. Eventually it will shutdown the motor
RE: Need help with 1st gen isx cm570 - Rawze - 06-24-2018
What is the voltage of the batteries?
RE: Need help with 1st gen isx cm570 - Ajr2000 - 06-24-2018
(06-24-2018 )Rawze Wrote: What is the voltage of the batteries?
Gauge is reading 12 volts. I don't have a tester so I can't check each one. I did disconnect all batteries cleaned and check for bad wires. Will a low battery or corroded wire cause this?
RE: Need help with 1st gen isx cm570 - Signature620 - 06-25-2018
Unplug the sensors listed in Chamberpains' images one at a time to see if the engine will stay running (check eng light will be on but stop eng light will be gone if one of the sensors is faulty)