2006 ISX, 475, Oil Pan Gasket... HELP... PLZ!!

[rtayl328]

Looking for info on 2006 Oil Pan Gasket Replacement.

1. Is there a gasket upside (to the block) or downside (to the pan) I should be aware of?

2. Is there a particular bolt pattern to use?
( Circular, just doesn't sit well in thought.. Pan is to large... I think! )

3. Use Silicone? Top side ( Block ), Silicone ( Pan Side ) or both?

4. Recommended silicone for reused oil pan, if any?

5. How much silicone to use, if any? 1/16 bead outside perimeter.


All help provided will Truly be Greatly Appreciated...

Thank You,

R. Taylor

[hhow55]

Go to Quickserve.cummins.com, and you will find the info you need

[rtayl328]

10-4. Thought, I needed E/SN to access after registering.. But forgot to get it while at yard today..

Thanks for the info..

[Signature620]

Oil pan gasket will fit correctly in all possible orientations. Small bead of silicone in each corner where the block joins the flywheel & gear housings (block side only). Tighten the bolts in a circular or middle-out pattern, whatever you like - up to 35ftlb.

[rtayl328]

Thank You Signature..

The old guy went to work again today and left yard without getting the ESN..

I even had the hood open to blow out air to air and Filter,, ETC...

Still closed the hood without even thinking about it...

[imalumberjack]

Other than whats been said: I tried to reuse old ....it leaked. On the corners make sure you scrape old silicone off first.