Looking for programming help

[ZeroNthedark]

Hello everyone,

I'll try to keep this short. Did a motor swap a couple years ago from 870 to an 871 that Haggai's had worked on. The swapper misrepresented his abilities and gave me a half-assed finished project. Got some issues fixed myself, Allison and Jerry fixed some more. I think the major issue is that the program needs some reworking. None of my old parameters were copied over (like rear end ratio, that sure killed it) and even though Jerry got me up and running by getting some tweaking done, it still leaves a lot to be desired. Unfortunately I was never able to get another appointment down there or I would drive back to ATL tomorrow.

What I'm hoping to find is someone within a few hours of the western PA area. I would rather take a drive than try to figure out Calterm 5.16. Using Insite is not a big deal, but C-term is just beyond my patience level right now, at least that version. Thanks for your time, any help or suggestions are very welcome!

[Rawze]

Copy program from ECM and e-mail it to me. It will be far easier for someone to go over the program and see what is missing, etc.. than it would be for paying someone hours of shop time for something they may or may not even be able to figure out.
info: https://rawze.com/forums/showthread.php?...5#pid72945

[ZeroNthedark]

(04-11-2026 )Rawze Wrote:  Copy program from ECM and e-mail it to me. It will be far easier for someone to go over the program and see what is missing, etc.. than it would be for paying someone hours of shop time for something they may or may not even be able to figure out.
info: https://rawze.com/forums/showthread.php?...5#pid72945

So the stars aligned and this thread is closed.

Extra special thanks to "Nostalgic" who offered the use of his computer (and his knowledge of the Mumble server) to get my program out and sent to Rawze, who fortunately happened to be at home and was willing to take the time on a Saturday to give it a badly needed makeover.

After most of a bottle of hot sauce and about a 1000 "What the f$%k"'s, my truck has never run or behaved better. I'm learning how to drive all over again.

My advice- Don't be a dummy, if you have any questions about what's in your ECM, get in touch with the man now, not later. I can't thank him enough getting me fixed up.

[Nostalgic]

Rawze, what's the best way to reduce a touchy fuel pedal for when he's driving across a rough lot? Increase Accelerator_Hysterisis % and/or Acctr_Pedal_Filter_Const ??