ProStar AC/Heater Blower Motor acting up?

[Waterloo]

(03-17-2016 )yamajason Wrote:  Heat at a connection = resistance. Resistance could be caused by a loose or corroded connection.

I agree, there should be twelve gauge wiring for the blower, but it looks to be around 16 gauge. It was an International mechanic that told me about this breaker/fuse issue. It is a common problem in these ProStars, at least that is what he stated to me. A serious design flaw. And I did check my wiring, it all looks good, at least at the connections at the blower and resistor... The fuse block, not so much. Another project...