Well, she bit the dust, In Frame this week...

[Waterloo]

(03-18-2016 )in2trux Wrote:  I guess the "custom tune" wasn't enough to save the old gal! ON THE BRIGHT SIDE, you will know what you have and what to expect and won't be pumping 6 lbs. of soot through it!

Couple of thoughts, if you're going to have the tranny out, do the rear bell housing gasket! As soon as you get everything back together it will start leaking.
Good time to do the Hi-Lo range valve if you haven't done it already, replace all clutch linkage and heim joints, trans cooler, lines. Much easier to do when everything is on the ground. I know you have to be careful not to build up the bill but if you have to do it in the next year you'll be kicking yourself besides doing the extra labour!
Instead of replacing the compressor, just do the head. Allot cheaper and that's what fails.

I'm assuming all new liners. Double check measurements on liner protrusion and torquing with the experts here.

You have an old hand doing the job. "Maybe" you could be an "assistant" cleaning and painting that is always half ass!

Anything you can do is in your favour!

Who's to say, done right this time it may go 1.5m! By then you'll be hanging out in GA with the old dogs on the porch sippin' sweet tea laced with a little JD green label!
Older and wiser.

https://youtu.be/bs4y5si8DGs
https://youtu.be/952h-AJ3Bcg

Let me ask you about that compressor... Mine is knocking pretty good, and I have had Cummins look at it, they said it is normal in regards to the knock. It only knocks when it is building air and then she of course quiets down. I was originally going to just do the head on it as you stated, tell me more about this. I know it entails cleaning out the lines, replacing the compressor head gasket and what else? Is it a new head that goes on there or is the old one reused?

And yes on the bell housing gasket, I am going to head down there today and add that to the list along with the other stuff you mentioned. There is a new tranny cooler going in, I'll have them throw in the lines too, along with the hi low, linkage and heim joints. Thank you sir!