| Help needed |
| 10-08-2017, (Subject: Help needed ) Post: #7 | |||
| |||
| RE: Help needed {site no longer valid} I followed this procedure and it shows a fluctuation from 60-90 ohms from pins D and C. If i remove the front resistor (under the venturi pipe where we block off the egr with the washers) it has the same values. I checked the resistor in the front out of the circuit and it shows 120.6ohms which should be fine. I haven't been able to find the other resistor. Does anyone know where I could find it? It looks like there could be a bad resistor or a short somewhere | |||
| « Next Oldest | Next Newest » |
| Messages In This Thread |
Help needed - INTERPRO - 10-08-2017, RE: Help needed - kmk - 10-08-2017, RE: Help needed - Rawze - 10-08-2017, RE: Help needed - INTERPRO - 10-08-2017, RE: Help needed - kmk - 10-08-2017, RE: Help needed - INTERPRO - 10-08-2017, RE: Help needed - Rawze - 10-08-2017, RE: Help needed - INTERPRO - 10-08-2017 RE: Help needed - INTERPRO - 10-08-2017, RE: Help needed - INTERPRO - 10-15-2017, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.