| Low beam fault |
| 12-11-2017, (Subject: Low beam fault ) Post: #1 | |||
| |||
| Low beam fault Hi everyone. First post in the forum. Not sure if this is the right forum to ask but here goes. Recently, I bought a 2013 W900L with an ISX and I'm slowly learning about the truck and doing repairs that needed doing. Today I took out the low beam lights and installed some Cree-style (Chinese knock off) LED lights in their place. (There were Speaker projector lights in before I swapped but one had burned out so I decided to try these lights.) Here's my problem....they are working perfectly EXCEPT I have a Low Beam Fault on my dash now. I'm surprised because I'm pretty sure the Speakers were LED and never had this fault message before the switch. Do I need to put a resistor inline somewhere? Thanks for any help | |||
| « Next Oldest | Next Newest » |
| Messages In This Thread |
Low beam fault - Skman - 12-11-2017 RE: Low beam fault - Bigstank - 12-11-2017, RE: Low beam fault - Rawze - 12-11-2017, RE: Low beam fault - Skman - 12-11-2017, RE: Low beam fault - stevesparts - 12-14-2017, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.