Turbo

[Waterloo]

After in framing my CM-871 TWICE, not due to tuning by the way, but having the wrong parts installed in my motor by the first shop... Dude, listen to these guys, I hope you have deep pockets. You are destroying your motor. I went to Rawze's house to in frame this truck, I just got her back on the road. I lived with the man and his family, he is telling you the truth, so is Unilever and everyone else here.

I hung out at Mr Hagg's shop with Rawze, Haggai Automotive and Diesel down in Griffin GA. Motor after motor with these crap tunes, rolling abortions is how I refer to them. Cooked heads, busted liners, broken rods, destroyed crankshafts/cams and melted turbos. Dude, from what I have read, your engine is more than likely toast.

I would PM Unilever, he is up in Camrose Alberta I believe. Maybe he could help, at least with an in frame. He would be the only man I would trust with that motor up your way. And get the hell away from that Edge tuning clown, before he puts a rod through the side of your block. I read "Edge tuner" and immediately cringed. Figure at minimum $30,000. Hopefully the block will be intact. Good luck.