Bent rear axle?
01-03-2019, (Subject: Bent rear axle? ) 
Post: #32
RE: Bent rear axle?
(01-02-2019 )imalumberjack Wrote:  When I was reading instructions it said nothing about sleeve!!! I did not like the 1/4 turn back as it lost all preload!!!!! Thanks! looks like I will be doing it again.

essentially, with spacers, final torque when it is all said and done at 200-300ft-lbs depending on axle type/model.

Without spacers installed, 50-80 ft-lbs final torque.

hubs should feel slightly tight, but can move with some medium effort on one finger stretched out straight.


User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!.
replyreply
 Thanks given by: imalumberjack


Messages In This Thread
RE: Bent rear axle? - tree98 - 12-29-2018,
RE: Bent rear axle? - Waterloo - 12-29-2018,
RE: Bent rear axle? - Waterloo - 12-29-2018,
RE: Bent rear axle? - Rawze - 12-29-2018,
RE: Bent rear axle? - Rawze - 12-29-2018,
RE: Bent rear axle? - Rockhwy - 12-29-2018,
RE: Bent rear axle? - tree98 - 12-30-2018,
RE: Bent rear axle? - Nilao - 12-31-2018,
RE: Bent rear axle? - Rawze - 01-02-2019,
RE: Bent rear axle? - Rawze - 01-03-2019
RE: Bent rear axle? - Nilao - 01-02-2019,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.