Cm2350 down 559 issues

[Ironsled]

Today’s up date is no good news . I took all the fuel line lose from the paccar filter base and blew them out a lot towards the tank with the tank side disconnected . Check the filter base top and sure nothing clogging that keep in mind these are new filters. And put it all back together . I got a big water bottle and put the line from lift pump side and put it in there and let it prime topped the bottle off with more fuel and started the motor . Right off She ran good , got down to about a 1/3 of fuel left and the motor died again . I also made sure the check valve in the banjo bolt on the drAin line off the back of the block was clean and was working properly and put back . I also took soap spray bottle and sprayed all connections looking closely for sucking or bubbling and found nothing .

On a new note . There’s a relay behind the gauge cluster clicks every couple mins with the key off

AND

When I use my keyless entry to look or unlock the truck normally my running lights will flash and hold a sec or two then-go off

Now my trailer looks like strobes for a couple secs before it goes off . I’m leaning on bad delete and or something in ecm . I only start with delete due to me and me. Hagg noticed my turbo was sitting at 77 on insite . Not good .... I’m lost trying to get a computer with insite sent to me over night to maybe do calibration and then rack my brain on delete back so don’t derate