Cummins recon engines.

[Mr Hagg]

(09-11-2019 )tree98 Wrote:  There was a thread on here about Mr. Hagg (if I remember right) getting a recon motor and ended up tearing it all down and re doing it because liner heights were all different and other problems.

We bought a new short block due to customers had a rod slung through the side. When I open up plastic you could see where cummins had made marks of what liners was and it was all across the board. and this was a brand new block so no reason it wasnt right. So I pulled crankshaft, pistons and liners back out and had Rawze do the counter bore....