Last straw

[Rawze]

(10-02-2019 )Lonestar10 Wrote:  Gona limp her home and rent a truck while she gets a new head and liners checked if measurements are off gona have liners pulled recut and set right.

I told him to let Mr. Hag replace the head and re-cut the liners, etc. so that it does not have to be questioned.

He said last night that he is instead going to put it back together and let someone else closer to him where he lives do it. He is convinced himself that his local mechanic can do the job the right ways. Personally though, I think that will be his next big mistake, seen it too many times.

-- Have I predicted the future?

Hopefully, I am wrong.


--- Also,.. I told him that if those liners are not sitting at 0.014" height when the head comes off, -- THEY NEED TO BE RE-CUT! and liners raised!. IF YOU PULL THAT HEAD OFF -- DO EVERYTHING NECESSARY FOR THE THING TO LAST ANOTHER MILLION MILES PROPERLY!!!!!!

That half-arssed Stealers$it that did it the first time is not likely to have done this no matter what the damn invoice of wasted $19,500+ money says.

We shall see if he is simply stubborn, or his continued gambling on his trucks future was or was not a wise decision.

-- Maybe he will read this post and see the irony in what he said last night ... If it were someone else and he was reading this thread, the correct things to do would be obvious I think.