Fuel pump question

[SIDE_SHOW]

i dont pull into a shop unless i have absolutely no other option... example pulled into a big box shop in brookshire tx last month because i had a wheel seal pouring oil out... long story short i had to make them go back and properly torque the inner nut to 300 ft lbs and they didnt clean a damn thing rawze had to help me do it while i was there... i would say this, invest in a cheap set of tools and keep them on or near you at ALL times and anything you can possibly so yourself do it.... if you dont know how, well there is no time like the present to learn with all the help readily accessible on this forum and on youtube.... these trucks arent rockets they are not hard to figure out... ive got all my tools and do almost all of my work... i am getting insite ASAP and i would do the same if i were you it will literally save you thousands in the long run...