Cm2250 swap to cm2350

[Valley11]

Took out 6.7cm2250 And Installed QSB 6.7L cm2350 Made all requirements to fit engine in and then repined the ecm connector. Engine will be demandated did not connect any emissions pin into ecm connector. I installed it in a logging loader not a truck. I turn key on communicates to display but will not crank. Insite will not allow full connection say ecu connected calibration selection error once connected. This is a new crate engine no idea what for was going to get it programmed after installed. Any help in someone that has swapped 2250 for 2350 before.