Volvo 670 with 2250

[Rawze]

(12-28-2020 )Volvo670 Wrote:  I have ran into a problem. The Volvo stealerships in my area only do ecm reflashing on the truck itself, they don't have the setup to do bench-programming. The only other option I could think of was to take it to an shop that "specialize" in ecm's but their programmer is out of vacation and won't be back till next week.
I was going to try a shop but, they got me in this mess to begin with so I didn't consider that...

Any other suggestions I'm not thinking about?

* have you gotten to pulling apart and finishing hollowing out all the cans including the SCR yet?

* Is there a maint. free Crank case filter installed?

* What other hardware mods or block-plates etc. have been done to it?

-- I can perhaps try to straighten out the bad file you sent me, as it is not as bad as some that I see, but it is far easier and safer to just start over so that it guarantees there are no hidden mistakes lurking in it from the ppl that butchered it originally.